User guide

To remove a preset, select it from the drop down menu and click the trash can icon.
Manual Hardware Configuration
There are two methods in manually selecting the frequency range for the Wi-Spy
configuration. You can enter a center frequency and select the frequency span or step
width. For example, if you entered “5775” into the Center Field and “20” for the span, it
would leave 10 MHz on both sides of the center frequency. Alternatively, you can enter the
start and stop frequencies. The Step Size and the Span are configured to automatically
display at least 10 data points.
Step Size
The step size defines the resolution displayed in the overview pane. To adjust the
resolution, increase or decrease the step size. A smaller step size will create a higher
resolution capture, but it will increase the length of time it takes to finish a sweep. A large
step size will lower the resolution, but will decrease the sweep time as well.
The default settings are optimized for both speed and resolution.
Chanalyzer by MetaGeek USER GUIDE page 24