User manual

6 BlackBox and WhiteBox F-2

32 W-DMX G4(S) User Manual, edition 2 2013-10

6.4 Installing the unit

Installation is identical to:

• BlackBox F-1: see chapter "4.4.1 BlackBox F-1", page 16.

• WhiteBox F-1: see chapter "4.4.2 WhiteBox F-1", page 17.

Hint

• You have to install two antennas.

• On BlackBox MK I and WhiteBox MK I, Universe 2 is

only available via RJ 45 port.

6.5 Switching FLEX modes

The FLEX mode determines if the unit is used in Transmit Mode (TX),

Repeater Mode (TX flashing) or Receive Mode (RX).

To switch the FLEX mode, proced as follows:

1. Disconnect the power cable.

2. Press and hold the left red function button (1) on the front panel

(Universe 1).

3. Reconnect the power cable.

4. Release the red function button (1).

 The FLEX mode is switched. The LEDs indicate the current mode: either

TX (2) or RX (3).

5. If necessary, repeat the procedure for Universe 2 on the right side of the

front panel. Functional elements are identical to the left side (Universe 1).