User manual

4 BlackBox and WhiteBox F-1

24 W-DMX G4(S) User Manual, edition 2 2013-10

To change the CTRL mode, proceed as follows:

 The unit is in Transmit Mode (TX), working as a transmitter.

1. Press and hold the red function button (1) on the front panel for at least

10 seconds.

 The CTRL LED (2) is on. TX, RX, DATA and LINK LEDs are rotating.

Hints

• Do NOT release the red function button (1) until TX, RX, DATA and

LINK start rotating and CTRL is on.

• Keep holding the red function button (1) even if the LINK LED starts

blinking. This allows you to go through the unlink mode without

unlinking.

• Old G4 software indicate CTRL mode with CTRL and TX on, RX,

DATA and LINK off. Therefore, to exit control mode with Old G4

software, unplug power.

• Old G4 software is compatible only in G3 and G4 mode.

G3 units are compatible only in G3 mode.

2. Release the red function (1) button.

3. Press the red function button (1) repeatedly until the desired mode is

displayed via the status of the following LEDs:

G4 LED RED SIGNAL LED

G3 2.4 GHz mode

G4 2.4 GHz mode

G4S 2.4 GHz mode

(on transmitter)

G4S 5.8 GHz mode

(on transmitter)

 The desired mode is set.

4. Press and hold the red function button (1) for 3 seconds.

 The unit exits CTRL mode (configuration) and CTRL LED turns off.

 Normal operation restarts.