User manual

4 BlackBox and WhiteBox F-1
22 W-DMX G4(S) User Manual, edition 2 2013-10
4.6.3 Unlinking all receivers
Use this procedure to unlink all receivers connected with the unit.
1. Press the red function button on the transmitter for 3 seconds, until the
LINK LED flashes slowly.
 The LINK LED on the transmitter flashes slowly:
 The signal bar of the receivers fall back to zero.
 LINK LED on receivers goes off.
 All connected receivers are unlinked.
Hint
To unlink one specific receiver, press and hold the red
function button on the specific receiver for 3 seconds, until
the LINK LED is off.
4.7 Operation as a receiver
 The unit is in Receive Mode (RX), working as a receiver.
4.7.1 Linking with transmitters
Hint
You can link receivers at any time, also during operation.
During the linking procedure the DMX transmission is
interrupted.
1. Power on the receiver.
2. Ensure that the receiver is not connected to any other transmitter, i.e., the
LINK LED on the receiver is off:
If required, see chapter "4.7.2 Unlinking from transmitters", page 23.
3. Press the red function button of the transmitter momentarily (1 second).
 The transmitter scans for all unlinked receivers for a period of about
5 seconds. The LINK LED flashes rapidly: