User manual

4 BlackBox and WhiteBox F-1

2013-10 W-DMX G4(S) User Manual, edition 2 19

10. Close the housing.

11. Tighten the 4 screws (1) by turning them clockwise.

4.5 Switching FLEX modes

The FLEX mode determines if the unit is used in Transmit Mode (TX) or

Receive Mode (RX).

To switch the FLEX mode, proceed as follows:

1. Disconnect the power cable.

2. Press and hold the red function button (1) on the front panel.

3. Reconnect the power cable.

4. Release the red function button (1).

 The mode is switched. The LEDs indicate the current mode: either TX (1)

or RX (2):