User manual

4 BlackBox and WhiteBox F-1
18 W-DMX G4(S) User Manual, edition 2 2013-10
When connecting a WhiteBox model it is necessary to open the housing.
Warning
Risk of death by electrocution!
AC power connection must be carried out correctly.
• Make sure that only a qualified, trained electrician
carries out AC power connection.
• Make sure the correct Schuko connector or other
connector suitable for your country is used.
1. Remove the 4 screws (1) by turning them couterclockwise.
2. Open the housing.
Caution
Damage to the unit!
•
Make sure no contact voltage is transferred when
touching the connection cables.
•
All non used Cable Glands need to be sealed to
achieve IP65 rating.
3. Loosen the cord strips (3) by turning the screws counter-clockwise.
4. Put the cables through the cord strips (3).
5. When using AC, put the AC power cables into the socket (see
chapter "4.2.2 WhiteBox F-1 MK I", page 13 or "4.2.3 WhiteBox F-1 MK II",
page 14) and tighten the bolts of the socket.
6. Couple the connectors to the cables:
– When using 12 V DC power, couple the 12 V DC power cable to the
Phoenix gold connector
– Couple RJ 45 connector:
MK I: to DMX signal cable (or Ethernet cable if option is installed and
should be used).
MK II: to the socket (see chapter "4.2.3 WhiteBox F-1 MK II", page 14)
7. Fit the connectors within the sockets (see chapter "4.2.2 WhiteBox F-1
MK I", page 13 or "4.2.3 WhiteBox F-1 MK II, page 14).
8. Fit the cord strips by turning them clockwise.
9. If the FFC cable to the overlay is loose:
– rotate the lid by 180°,
– insert the FFC cable,
– secure the FFC cable in the connector
– rotate back the lid before you close the housing.