User manual

7 Micro units
7.1.3 LEDs
Fig. 11: LEDs of Micro F-1 Lite
SIGNAL/BATT: Identifies if the signal strength or battery power is displayed on
the LED bar.
Other LED signals are identical to F-1 (see chapter “4.3 LEDs“, page 14).
Note
Micro F-1 Lite does not have the G4 5.8 GHz mode.
7.1.4 Installing the unit
1. Choose one of the following options to make the DMX connection:
– Connect the DMX source to the DMX IN / OUT port.
– Connect the DMX fixture to the DMX IN / OUT port.
2. Connect the power supply to the DC power input.
7.1.5 Switching FLEX modes
The FLEX mode determines if the unit is used in Transmit Mode (TX) or
Receiv
e Mode (RX). Switching the FLEX mode is identical to the BlackBox
F-1, see “4.5 Switching FLEX modes“, page 17.
7.1.6 Operation as a transmitter
Operation as a transmitter is identical to the BlackBox and WhiteBox F-1, see
chapter "4.6 Operation as a transmitter", page 18.
7.1.7 Operation as a receiver
Operation as a receiver is identical to the BlackBox and WhiteBox F-1, see
chapter "4.7 Operation as a receiver", page 21.
32 W-DMX G4 User Manual, edition 1 2012-02