User manual

6 BlackBox and WhiteBox F-2

6.4 Installing the unit

Installation is identical to:

• BlackBox F-2: see chapter “4.4.1 BlackBox“, page 15.

• WhiteBox F-2: see chapter “4.4.2 WhiteBox“, page 16.

Notes

• You have to install two antennas.

• On BlackBox MK I, Universe 2 is only available via

RJ45 port.

6.5 Switching FLEX modes

The FLEX mode determines if the unit is used in Transmit Mode (TX) or

Receive Mode (RX).

To switch the FLEX mode, proceed as follows:

1. Disconnect the power cable.

2. Press and hold the left function button (Universe 1) on the front panel (1).

3. If necessary, repeat step 2 for Universe 2 on the right side of the front

panel. Functional elements are identical to the left side (Universe 1).

4. Reconnect the power cable.

5. Release the function button.

 The FLEX mode is switched. The LEDs indicate the current mode: either

TX (2) or RX (3).

2012-02 W-DMX G4 User Manual, edition 1 29