User manual

4 BlackBox and WhiteBox F-1
2. Ensure that the receiver is not connected to any other transmitter, i.e., the
LINK LED on the receiver is off.
LINK (off)
3. Press the function button of the transmitter for 1 second.
 The transmitter scans for all unlinked receivers for a period of about
10 seconds. The LINK LED flashes rapidly.
LINK (rapid flashing)
 If the connection is successful, the LINK LED on the receiver goes on. If
DMX input is available, the DATA LED goes on as well.
DATA (on)
 If the connection fails, check the position of the receiver, see chapter "4.6.1
Prerequisites for successful linking", page 18.
 The signal bar on the receiver indicates the received signal strength.
4.6.3 Unlinking all receivers
Tx Tx
Rx
Rx
1.
2.
Use this procedure to unlink all receivers connected with the unit.
1. Press the function button on the transmitter for 3 seconds, until the LINK
LED flashes slowly.
 The LINK LED flashes slowly.
LINK (flashing)
 The signal bars of the receivers fall back to zero.
 All connected receivers are unlinked.
Hint
To unlink one specific receiver, press and hold the function
button on the specific receiver for 3 seconds.
20 W-DMX G4 User Manual, edition 1 2012-02