User manual

4 BlackBox and WhiteBox F-1
When connecting a WhiteBox model it is necessary to open the housing.
Warning
Risk of death by electrocution!
AC power connection must be carried out correctly.
• Make sure that only a qualified, trained electrician
carries out AC power connection.
• Make sure the correct Schuko connector or other
connector suitable for your country is used.
1. Unscrew the housing by the 4 screws (1).
2. Open the housing.
Caution
Damage to the unit!
•
Make sure no contact voltage is transferred when
touching the connection cables.
3. Loosen the cord strips (3) by turning the screws counter-clockwise.
4. Put the cables through the cord strips (3).
5. When using AC, put the AC power cables into the socket (see chapter
“4.2.2 WhiteBox“, page 13) and tight the bolts of the socket.
6. Couple the connectors to the cables:
– When using 12 V DC power, couple the 12 V DC power cable to the
Phoenix Gold connector
– Couple RJ 45 connector to DMX signal cable (or Ethernet cable if option
is installed and should be used).
7. Fit the connectors within the sockets (see chapter “4.2.2 WhiteBox“,
page 13).
8. Fit the cord strips by turning them clockwise.
9. Close the housing and fit the 4 screws (1) by turning them clockwise.
4.5 Switching FLEX modes
The FLEX mode determines if the unit is used in Transmit Mode (TX) or
Receive Mode (RX).
To switch the FLEX mode, proceed as follows:
1. Disconnect the power cable.
2012-02 W-DMX G4 User Manual, edition 1 17