User manual

User Manual - English

1. Radio Compliance Information

FCC IDENTIFIER:

NY2-WDMXTRX

Name of Grantee:

Wireless Solution Sweden Sales AB

Equipment Class:

Part 15 Spread Spectrum Transmitter

FCC Rule Parts:

12C2402.0

General Notes

: The antenna(s) used for this transmitter must be installed to provide a separation

distance of at least 20 cm from all persons and must not be co-located cooperating in conjunction with

any other antenna or transmitter. Users and installers must comply with operating manual.

This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used

in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference, in which case

users will be required to correct the interference at their own expense.

Modification Warning!

Changes or modifications to this equipment, not expressly approved by

Wireless Solution Sweden Sales AB could void the user’s authority to operate the equipment or void

the FCC approval and negate your authority to operate the product.

Safety Notices:

Please read this entire manual before using your new equipment. Please keep the

manual in a safe place so you can refer to it in the future as required.

W-DMX™ is intended for use only by qualified lighting professionals. Connection, installation, and

hanging of this equipment must be performed in accordance with all pertinent local, regional, and

national safety codes and regulations.

This equipment shall not be used to operate moving-scenery or moving-truss structures, DMX-

triggered motors/hoists or lifting devices including, but not limited to, stage lifts operated by DMX,

hydraulic systems or any moving component that may cause harm to human-beings in case of failure.

It should not be used to trigger flames or pyro equipment, explosive powered tools or compressed air

equipment. It shall also not be used with water pumps or any water related equipment triggered

wirelessly and subject to failure where it may cause harm to human-beings.

Please do not use with any theatrical flying and rigging operations, or any device that may fail due to

break of RF signal. W-DMX™ products shall not be used with firearms or weapons triggered by wireless

equipment.

Please keep the equipment dry unless it is clearly specified to work outdoors. Do not operate in

excessive heat or direct sunlight, and provide adequate ventilation.

Do not place anything on top of the Products that weighs more than 5 pounds (2.25 kg). Excessive

weight on top could damage the chassis.

There are no user-serviceable parts inside. All serviceable work shall be done by qualified service

personnel, generally appointment by the Manufacturer.

The Product is furthermore not intended for use within a non-entertainment, architectural or motion-

picture lighting related business, such as: