User manual

User Manual - English
12
5.6. Enabling 5 GHz
Due to the different regulations worldwide, all W-DMX
TM
devices come with 5 GHz disabled from
front-interface control. This must be enabled with the W-DMX
TM
Dongle and Configurator software,
available from the website. Once on, you may be able to scroll through all modes.
5.7. Double-Up Mode
To enable Double-Up mode make sure that your W-DMX™ G5 has got the latest firmware. Please
contact our helpdesk for guidance. You can find the correct I/O assignments under the dedicated
pages for each product – please note these have changed from previous manuals, with the corrected
version addressed in the 3
rd
edition of the manual.
5.8. Repeater Mode
All F-2 models are capable to operate as repeaters, as long as configured to do so:
1. Set the device to G3 mode.
2. Cycle through the radio direction like in 5.4.
3. ThecyclesequenceinF-2units is: TX–TX; RX–RX; RX-TX
4. Use this last sequence to make your F-2 unit to repeat.
5. Pair the first transmitter in the chain to the RX side of the F-2 unit in G3 Mode.
6. Establish the TX link with succeeding receivers.
5.9. Switching Off UNV 2
With F-2 models you can switch off RADIO B.
When the unit is in (TX, TX) direction, RADIO B can be turned off by pressing the button for RADIO B
during power up. When turned off, the PWR LED in RADIO B will turn off.
To enable RADIO B, press and hold the button for RADIO B during power up.