User's Manual

Draft

24 RT 1000 v1.3 Deployment Guide R03.d

Layout

Laying Out the Equipment

2 Pick up the WRU and point the geophone connector end towards the ground as

shown in the following figure. After a few seconds, all of the LEDs illuminate:

3 Place the unit flat on the ground as shown in the following figure:

NOTE

If you are using a WRU as a Repeater, the deployment instructions are

the same, except a geophone is not required.

If a geophone is not connected, you can skip the geophone test. See

“LED Indicators” on page 93 for more information on skipping the test

and the relevant LED status indicators.

Figure 2–11 Power on the

Unit

Figure 2–12 Place the Unit