User's Manual

Draft

RT 1000 v1.3 74 Deployment Guide R03.d

Demobilization

5.1 Overview

This chapter describes how to prepare (undeploy) the ground electronics for

transport at the end of a project (demobilization).

5.2 Removing the WRU from the Field

This section describes the process to ready the WRU for movement to a new

physical location or to remove it in preparation for demobilization.

To undeploy the WRU:

1 Prerequisites:

● The WRU is assembled with battery, geophone, and antenna

● The WRU is in an active, transitional, or ready state

2 Pick up the WRU and point the geophone connector end towards the sky as

shown in the following figure. All of the LEDs illuminate:

3 Place the unit flat in the transportation vehicle as shown in the following

figure. The unit shuts down. The LEDs on the top of the unit are off.

Figure 5–1 Power Off the

Unit