User's Manual Part 1

Draft
56 RT System 2 v2.3.0 Deployment Guide R01.b
© 2010-2013 Wireless Seismic, Inc. All rights reserved.
3. Backhaul
Setting up the Backhaul
11 Attach the cables:
● Bullet radio installation – Attach an elbow
connector [LR-14] to the antenna and then
an armored cable [LR-7, LR-8] to the elbow
connector.
Match white-to-white and green-to-green if
your panels are color-coded.
● Rocket radio installation:
► Open the protective metal case if the
Ethernet cable is not already attached.
► Connect the GPS antenna if it is not
already connected.
► Connect a short Ethernet cable [R-8] to
the radio [R-3].
► Close the protective metal case.
► Open the surge protector case [R-9].
► Remove the rubber grommet from the
surge protector case and cut some slots
in it.
► Thread two Ethernet cables [R-8, R-10]
and a ground wire [BK-14] through the
grommet and place the grommet back in
the case.
► Plug the Ethernet cables into the
shielded RJ45 jacks. It does not matter
which cable goes to which jack; the unit
provides bidirectional protection.
► Attach the ground wire to the ground
lug.
► Close the surge protector case and
secure it to the mast with the hose
clamp.
Table 3–10 How to Set Up the Backhaul
Step Image