User's Manual Part 1

Draft
R01.b RT System 2 v2.3.0 Deployment Guide 15
© 2010-2013 Wireless Seismic, Inc. All rights reserved.
2. Layout
Laying Out the Equipment
The RT System 2 shall be used with only the supplied antennas (Table A–1 Antenna
Specifications, on page 143) attached to the WRU with an integrated type N male connector.
 The RT System 2 antennas shall be installed and handled by professionals specifically
designated for this purpose.
 Changes or modifications not expressly approved by Wireless Seismic, Inc. can void the
users’s authority to operate the equipment.
Figure 2–4 Assembling WRUs
WARNING
In order to comply with radio frequency (RF) exposure requirements, the RT
System 2 units must be installed so that a minimum separation distance of 20
cm is maintained between the antenna(s) and the body of all persons at all times
during normal operation.