User's Manual

5Mbps Draft

R03.h RT 1000 1.5.0 Deployment Guide 25

2. Layout

Laying Out the Equipment

2.5 Laying Out the Equipment

You can lay out the ground equipment while the central recording system

hardware and software is being prepared.

The WRU is shown in the following figure:

The BSU is shown in the following figure:

An example geophone is shown in the following figure

2.5.1 Prerequisites

You can attach the batteries, antennas, and geophones to the ground equipment

prior to going into to the field, or as you place each unit. If you are assembling as

you place the units, ensure that you have sufficient quantities for each unit, plus a

few spares.

The RT 1000 shall be used with only the supplied antennas (Table A–1 Antenna

Specifications, on page 90) attached to the WRU with an integrated type N male

connector.

 The RT 1000 antennas shall be installed and handled by professionals

specifically designated for this purpose.

 Changes or modifications not expressly approved by Wireless Seismic, Inc. can

void the users’s authority to operate the equipment.

WHT = White, ORG = Orange, GRN = Green, BLU = Blue, BRN = Brown, BLK= Black,

YEL = Yellow

* Connect per Pin Numbers

Wire colors in parenthesis are for Ethernet cable wired per T-586A standard.

Table 2–4 BSU at Recording Truck (60-0012) Cable Pin List (cont.)

Signal Name Wire Color

27-Pin

Connector

Illustration TBD

Figure 2–10 WRU

Illustration TBD

Figure 2–11 BSU

Illustration TBD

Figure 2–12 Geophone