User's Manual

5Mbps Draft

14 RT 1000 1.5.0 Deployment Guide R03.h

2. Layout

Setting Up the Central Recording System

 Interface card jumpers

● Isolated remote start (J3, J4)

● Negative-edge timebreak (J5, J6)

 Menu settings

● Start Delay = 1000

● TimeBrk Act = LOW

● Make a note of the VibratorID. It must be entered as a parameter in the

CSS. (MAIN MENU

→ 1. JOB PROFILE → 7. VibratorID)

To connect and configure the Pelton Vib Pro:

1 Prerequisites:

● The central recording system computer is installed

● The CSS software is running

● The Vib Pro is powered down

2 Open the back of the Vib Pro and remove the interface card. Use proper anti-

static precautions.Refer to the Pelton documentation as necessary.

NOTE

Detailed instructions on using the Pelton Vib Pro are beyond the scope

of this document.