User's Manual

5Mbps Draft
42 RT 1000 1.5.0 Deployment Guide R03.h
© 2010-2012 Wireless Seismic, Inc. All rights reserved.
3. Backhaul
Backhaul Components
3.2.4.1 Mast
Lightweight, telescoping backhaul masts are used to elevate the backhaul
components above obstructions and to enable radio communications to
accommodate typical cross-line distances. The mast can be installed by a single
person. The following figures show the mast components:
3.2.4.2 Base
There are two base options; one that requires the use of guy wires for stabilization
and one that uses weights for stabilization.
• 3 each tent stake, steel, 12 in (70-0061) (hard
ground stakes)
“Backpack Kit” on page 45
• 3 each tent stake, plastic, orange, 16 in (70-0060)
(soft ground stakes)
“Backpack Kit” on page 45
• 5 ea nail, 12 in (70-0062) “Backpack Kit” on page 45
• 3 each guy line holder (70-0063) “Backpack Kit” on page 45
• 1 each hammer, 2.5 lb (70-0064) “Backpack Kit” on page 45
• 1 each pry bar, 15 in (70-0065) “Backpack Kit” on page 45
• 2 each flagging roll, orange (70-0066) “Backpack Kit” on page 45
• 1 each compass sighting (70-0067) “Backpack Kit” on page 45
• 5 each hose clamp, 2 in (70-0068) “Backpack Kit” on page 45
Figure 3–12 Mast (55-0008)
Table 3–4 Mast Kit (cont.)
Remote Backhaul Components
Item Reference