User's Manual

Preliminary
R01 RT 1000 v1.0 Deployment Guide 15
© 2010-2011 Wireless Seismic, Inc. All rights reserved.
Layout
At the Site
2.3.1 Set Up the Central Recording System
Set up the computer and peripheral equipment in the central recording system
truck or trailer.
2.3.2 Lay Out the Equipment
You can lay out the ground equipment while the central recording system
hardware and software is being prepared.
The WRU is shown in the following figure:
The LTU is shown in the following figure:
An example geophone is shown in the following figure
2.3.2.1 Prerequisites
You can attach the batteries, antennas, and geophones to the ground equipment
prior to going into to the field, or as you place each unit. If you are assembling as
you place the units, ensure that you have sufficient quantities for each unit, plus a
few spares.
The RT 1000 shall be used with only the supplied antennas (Table 9–1 Antenna
Specifications, on page 31) attached to the WRU with an integrated type N male
connector.
The RT 1000 antennas shall be installed and handled by professionals
specifically designated for this purpose.
Changes or modifications not expressly approved by Wireless Seismic, Inc. can
void the users’s authority to operate the equipment.
2.3.2.2 Assemble the Ground Equipment
This section describes the process to assemble the ground equipment prior to
deployment.
Illustration TBD
Figure 2–1 WRU
Illustration TBD
Figure 2–2 LTU
Illustration TBD
Figure 2–3 Geophone
WARNING
In order to comply with FCC radio frequency (RF) exposure
requirements, the RT 1000 units must be installed so that a minimum
separation distance of 20 cm is maintained between the antenna(s) and
all persons at all times during normal operation.