User manual
Company Condential Proprietary
XMC-K15 Interface cable
: for Kenwood 15 Pin radios using KCT-39 cable/TK7160 etc
V0
X10DR
¥
150cm
"J1"
FEMALE, 15-CONTACT
D-SUB CONNECTOR
WG*15C +ADB
unstripped
50cm
In-line fuseholder
1A FB fuse
Drain
Red
1
3
4
5
6
7
8
9
13
Drain connects to shell
Switched B+ from radio
Ext Mic Hi
Mic Lo to radio
Received audio from radio
Ext PTT to radio
Emergency out to radio
COR/ Audio unmute from radio/TOR
DC/ Digital Ground
Remote/ footswitch/Handle bar PTT
DB15 F
S
1A FB fuse
Battery
1
5
3
4
7
15
11
3
WH
BLK/WH
RED 22AWG with fuseholder
NOTE: e XMC-K15 Cable is factory set up for KCT-19 Kenwood interface cable.
To use with KCT-39 you must rewire the XMC-K15 molex 15 pin connector as per the following:
Additionally, you must move two wires in connector CN3 of Kenwood’s KCT-39 cable. (see insert)
Note: X10DR must be set for 200mV mic audio out (pin2) - may require use of XPK programmer.
Note: TK7160 is only capable of providing carrier squelched Rx audio which means if others are sharing the
channel on dierent CTCSS codes will be heard unless VOX is disabled in X-ponder unit (see page 4).
view from rear (wire insert side)
SHIELD/DRAIN
1
2
3
4
5
6
7
8
1
3
4
5
6
7
8
9
10
11
CN2
CN3
You must
Program Radio FNCs :
FNC3 =Pins 7 : PTT
FNC7=Pin 11 : TOR
FNC1=Pin 15 : Emergency
e following wire needs to be
moved in CN3:
-Wire in position 3 move to Position 7
-Wire in position 2 move to Position 4
KENWOOD
KCT-39 cable assembly
BLK
BRN
RED
ORG
YEL
GRN
BLU
PUR
GRY
BLK/WH