User manual

vii/Blasting Areas and Posted Facilities: To avoid interfering with blasting opera-

tions, turn off the X10DR when in a “blasting area” or in areas posted “Turn off

two-way radio.” Obey all signs and instructions.

Exposure to Radio Frequency Energy:

The unit transmits and receives radio frequency (RF) energy through its an-

tennas. The antennas are located at the top edge of the unit. The Wireless

Speaker Microphone is designed and manufactured to comply with the limits

for exposure to RF energy set by international regulatory agencies, including

the FCC of the United States, IC of Canada, MIC of Japan, and the Counsel of

the European Union, among others. The unit has been tested and meets the

FCC, IC, and European Union RF exposure guidelines for 802.15 operation. To

ensure exposure levels remain at or below the maximum safe levels, when car-

rying the unit ONLY use the Wireless Speaker Microphone with the manufac-

turer’s supplied clothing clip or a non-metalic holder that ensures the antenna

remains greater than 10mm (2/5 inch) from your body at all times. An external

antenna is connected to the output connector on the mobile charger or to

the output connector on the XBDA bidirectional amplier. Always keep your

body at least 20cm (8”) from the antenna whip. The XBDA is only approved

for use with this mobile charger unit in accordance with FCC regulations� refer

FCC ID: I7OBT-24D�

Potentially Explosive Atmospheres:

Turn off X10DR when in any area with a potentially explosive atmosphere. Do

not charge X10DR, and obey all signs and instructions. Sparks in such areas

could cause an explosion or re, resulting in serious injury or even death.

Areas with a potentially explosive atmosphere are often, but not always,

marked clearly. Potential areas may include: fuelling areas (such as gas sta-

tions); below deck on boats; fuel or chemical transfer or storage facilities;

vehicles using liqueed petroleum gas (such as propane or butane); areas

where the air contains chemicals or particles (such as grain, dust, or metal

powders); and any other area where you would normally be advised to turn

off your vehicle engine.

Repairing or Modifying X10DR:

Never attempt to repair or modify X10DR yourself. X10DR does not contain

any user-serviceable parts, Disassembling an X10DR, including the removal

of external screws and back cover, may cause damage that is not covered

under the warranty. If an X10DR has been submerged in water, punctured, or

subjected to a severe fall, do not use it until you take it to an WCL Authorized

Service Provider. Service should only be provided by WCL or an WCL Author-

ized Service Provider. If you have questions or for service information, contact

WCL or an WCL Authorized Service Provider.

Battery Replacement:

Do not attempt to replace the rechargeable battery in X10DR yourself. The

battery should be replaced only by WCL or an WCL Authorized Service Pro-

vider. The battery should be re-cycled/disposed of thoughtfully.

X10DR