User manual

Re-connection

Each X10DR Secure Wireless Microphone is uniquely

connected to a specic X-Ponder mobile charger. This

ensures that all communications between the two units

are secure and cannot be compromised or interfered

with by a third party. In the event of a Secure Wireless

Microphone being lost, it can be permanently discon-

nected from the X-Ponder mobile charger by connect-

ing with a new replacement Secure Mic unit.

How to re-connect: hold the speaker mic while pressing

both the blue up and down volume controls until the

blue LED ashes and the speaker mic beeps.(after 8 secs.)

Press together

until LED ashes

and unit beeps

Now place the speaker mic back

into the mobile charger. After a few

seconds the speaker mic will sound

a conrmation two tone and the

blue LED on both units will glow solid

to indicate connection is complete.

Audio adjustments

The Secure Wireless Microphone sys-

tem is usually factory set for standard

audio levels required to provide sat-

isfactory mobile radio voice levels.

Should the volume be too soft or

loud and distorted, it may require re-

adjustment to set the correct level

for your particular installation.

Using a radio systems analyser to monitor the radio

channel adjust the internal trim pots so as to achieve

maximum permitted voice deviation within minimum

voice clipping (distortion).

See Page 16 for adjustment points.

Qualied service personnel only!

VR1

- Tx

VR2 - Rx