User Guide

Handset Programming:
Basic functions
PTT
Microphone
Status
light
Right 1
Top 1
Left 1
Left 2
Top 2
3.5mm earpiece audio jack
Hirose audio jack
Charging Contacts
Internal Mic Only Operation
Maintains operation via internal microphone when accessory attached to Hirose
port.required for earpiece (WPEH-X10/WPTEP-X10) use via Hirose headset port.
Default - OFF
Out of range turn off time
Sets time in hours that a handset that is not actively connected to a gateway will
remain powered on before turning itself off.
Default - 8 hours
Low battery beep voltage
Sets the remaining battery voltage that will cause the low battery alert tones to
be generated.
(for longer shift life you may set voltage lower but you may get less
warning before device automatically shuts off.
Default - 3.5V
Low battery beep interval timer
Sets the interval that the low battery alert tones are sounded in the handset.
Default - 5 minutes
Elite Plus Only Options
Handsfree Function (shows “disabled” if feature not enabled)
Enables user selectable handsfree intercom function in Elite Plus handsets.
Default - ON
Toggle PTT/TA Button Assignment
Configures handset so that pressing the top grey Control button toggles the
side PTT button assignment between host radio PTT and Talkaround or 2nd
Radio device PTT /PA Mode when used with XSJB or similar.
Default - OFF
Command Relay Mode / Automatic Relay Mode
Selects the Relay Mode type in Elite Plus handsets.
Default - Command Relay (manual - normally OFF)