User's Guide

Wireless Matrix MBS2 User Guide Document MBUD-0086v1b
MBS2 User Guide
INTRODUCTION
This guide explains procedures for using the Wireless Matrix Mobile Base Station 2 (MBS2) modem as
installed on a vehicle for data communications.
Technical Support
Technical questions should be directed to the Customer Care team at [phone].
Regulatory Statements
The following regulatory approvals apply for the Mobile Base Station 2 (MBS2):
• FCC
• IC
• PTCRB
FCC Part 15 Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause
undesired operation.
Modifications not expressly approved by Wireless Matrix USA, Inc. could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
March 04, 2004 Page 4