User's Manual

Document Number 050-015-008R05
Wireless Mmatrix Proprietary and Confidential 10/20
Procedure if antennas require drilling:
1. Drill a 3/4” diameter hole for each antenna. Use existing mounting holes, if
available. Otherwise, start by drilling a small pilot hole, and then use a
universal drill bit to slowly enlarge the hole until the antenna connector can fit
through. Clean the roof area where the antenna will mount to get a good seal.
Use tar tape or silicone to ensure water tightness. Seat the antenna through
the hole, making sure any gasket attached to antenna seals the entire
perimeter.
2. Attach any nuts or bolts from the inside as necessary.
3. Attach antenna connectors to the COMMUNICATOR 1000.
Procedure if antennas do not require drilling:
1. Attach adhesive or magnetic-mounted antenna in the desired location.
2. Run antenna cables through the driver-side A-pillar.
3. Attach antenna connectors to the COMMUNICATOR 1000.
NOTE: DO NOT PUT ALL YOUR WEIGHT ON THE ROOF OF THE TRUCK OR APPLY
EXCESSIVE DRILLING PRESSURE. You may inadvertently put dents in the roof.
Stand on the edges of the doorway, or on top of the cowling of the hood.