User's Manual

PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 7 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax [phone] www.wrx-ca.com
Conventions
The Terrestrial Processor Assisted Connector will be referred to as the TPAC from this point
forward.
TPAC configuration commands are displayed in bold type followed by < >. The < >
brackets indicate a variable should be entered.
Example: GDN ADd <pid><index><address><f1><f2><f3><f4><type>
The TPAC interface uses minimum truncation. This means that only the letters that are
capitalized need to be entered when programming the TPAC. The TPAC is not case
sensitive. The menu structure in the TPAC configuration contains headings and subheadings.
The command tree will be displayed as follows.
RTU
DEBug OFF
MAXRetries 2
RXTimeout 1
COMM
Baud 9600
DataBits 8
Parity None
StopBits 1
Commands are entered as follows; to change the RTU debug settings type.
RTU DEBug on