User's Manual

PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 49 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax [phone] www.wrx-ca.com
5.10 Pressure Trax ILI Technologies Driver
RTU Driver : ILI Technologies : PressureTrax V1.1
KeyCode : PRT
Driver configuration:
RTU
TYpe PRT – Set the RTU driver to the PressureTrax.
DEbug <off | on>
RXTimeout <8> – The default is 5.
MAXRetries <2> – The default is 2.
COMM
POrt < COM2> – The RTU driver must use COM2 (RS232).
BAud <4800>
DAtabits <8>
PArity <None>
STopbits <1>
PRT Driver I/O Configuration
GDN ADd <pid> <index> <address> <f1> <f2> <f3> <f4> <type>
IO Point Configuration
Address
:
not used.
F1 : Point Index - See table below
F2 : not used
F3 : not used
F4 : not used
Type : See table below
F1 Type Data form PRT
1 Uint Current raw pressure data Channel 1
2 Uint Current raw pressure data Channel 2
3 Uint Current raw pressure data Channel 3
4 Blob EEPROM Data block [ 128 bytes]
5 Blob SRAM Block #0 [1024 bytes]
6 Blob SRAM Block #1 [1024 bytes]