User's Manual

PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 17 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax [phone] www.wrx-ca.com
Figure 10: Display the version
3.2.2 Setting PAC Values
The “SHow” command displays all the PAC settings. The settings are displayed as a tree of
main settings with sub settings. To set a specific value, the complete path to the setting must
be given.
For example, to set the RTU’s baudrate, issue the command…
RTU COMM BAUD <baud rate>
3.2.3 Loading Drivers
The default RTU driver in the PAC is Modbus. The network driver for a TPAC with a
DataTAC module is Radio Access Protocol (RAP). A new RTU driver can be specified if
necessary. This should be done before any other settings are changed. When a drivers is
changed, the PAC will reboot and set default values for the new driver. For example, type
RTU TYPE DF1 to load the DF1 driver. This will change the RTU driver to DF1, save the
RTU driver and cause the PAC to reboot and restore relevant values for the DF1 driver.