User's Manual

PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 16 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax [phone] www.wrx-ca.com
3.2 TPAC User Interface
This section assumes the programmer has the basic understanding of the TPAC functionality
and the end devices connected to the TPAC. The TPAC is configured using the PAC
command line interface. The PAC command line interface has a tree structure and uses
minimum truncation so only letters necessary to make the command unique need to be
entered. The manual shows the necessary characters in capital letters. The PAC command
line interface is not case sensitive. When the TPAC powers up, the terminal screen displays
the firmware version, electronic serial number and the network and RTU drivers that are
loaded.
3.2.1 General PAC Commands
The following list of general PAC commands:
HALT – Halt execution of the PAC. This is useful when configuring the PAC.
RUN – Start PAC execution.
SHow – Display the entire PAC configuration.
SHow PAC – Display the parameters that are applicable to the PAC application.
SHow RTU – Display the parameters that are applicable to the RTU or end-device.
SHow NET – Display the parameters that are applicable to the network device (Radio).
HElp – List all the commands and the format for each command.
WRite – Save the current configuration in non-volatile memory.
REBOOT – Restart the PAC as if power was first applied. The PAC will start with the
configuration stored in non-volatile memory. The PAC will start in RUN mode.
VERsion – Display the firmware version and the loaded and available drivers. See the
following screen capture.