User's Manual
PAC Configuration Manual
Wireless Matrix Corporation #102, 1530 - 27 Avenue NE Page 14 of 62
Document # xxx-xxx-xxx Calgary, AB, Canada T2E 7S6
2002.02.01 Ph. 403.250.3949 Fax 403.250.8163 www.wrx-ca.com
Select the COM port for the serial port connected to the TPAC.
Figure 8: Choose a COM port
Specify the communication settings, as shown below.
Figure 9: Specify port settings
Click the OK button. Then click on the Call Disconnect and then Call Connect buttons.
(New port settings do not take effect until the session has been disconnected and
reconnected.)
Hit <enter> and the PAC> prompt should appear. .
The TPAC is ready for configuration.