User's Manual

iRespond System Setup

Linksys USB Hub Setup

• Attach USB cable to hub. Locate an available USB port on the computer and attach the other end of the USB

cable to this port. Attach the power adapter into the hub. Plug the adapter into a standard electrical outlet.

The hub will be automatically detected by the computer and is now ready for use.

Base Unit Setup

• Screw in the base unit antenna on the top of the unit. To maximize transmission, orient the antenna so that it

sticks straight up from the unit.

• Using the USB cable provided with the system, connect the end with the mini USB connector to the base unit.

Locate an available USB port on the Linksys hub. Connect the other end of the USB cable to the port.

• Apply power to the base unit by pressing the Power On/Off button in the upper-left of the unit.

• Setup for the base unit is now complete.

Remote Unit Setup

• Apply power to the remote units by pressing the Power On/Off button in the upper-left of each unit. Take

note of the UID number that appears on the bottom of the LCD. This UID number also appears on the back of

the remote unit on a separate label below the FCC Label.

The iRespond hardware setup is complete.