User's Manual

UM04725

June 7, 2004

Rev -

addition, information about the user, the number of questions answered/remaining, and

the device number the user is employing can be displayed on the personal computer

display.

When the user has completed the test, the user will submit the test for scoring. The

Remote will deliver any remaining or updated information to the Base Unit PC. This

information will be passed through to IRESPOND for immediate grading and storage.

Once the test has been graded the instructor will have the ability to immediately review

results and/or print reports.

2.5 Battery Charging. The Remote units are shipped with battery packs installed but

uncharged. The battery charger is capable of bringing a battery pack from completely

discharged to fully charged in approximately 3 hours. The Remote utilizes NiMH

batteries in a 3 cell configuration. The Remote provides a low battery indication when the

batteries reach 20% of capacity. Battery life is dependent upon operator use. The battery

charger is connected to the Remote with a short 2 foot cable. One end of the cable has a 3

pin connector which inserts into the battery charger. The other end of the cable has a

single prong audio jack connector which is inserted into one end of the Remote. The

remote is not powered on during charging. While charging the battery charger will

illuminate a red LED. When charging is complete the red LED will extinguish. The

battery charger and cable are shown in Figure 5.

Figure 5. Battery Charger