User's Manual

iRespond UltraLite Technical Manual 1
UltraLite/Lite Base Unit
Change the Base’s Channel
1. Press the power button to turn on the Lite base.
2. Immediately press F1 while Wireless eSystems scrolls across the base’s
screen.
3. When Device Address appears press ENT
. (This number should not be
altered).
4. Select ENT
at Output Power.
5. Output Channel should now be displayed.
6. Use the up and down buttons to change the base’s channel.
7. Press ENT four more times to save and exit configuration mode.
8. The base will automatically shut off.
Adjust the Power Output
The Power Output is set to 0 when shipped. The power output may be changed to help
strengthen the RF signal when transmitting to many remotes or at far distances.
1. Press the power button to turn on the Lite base.
2. Immediately press F1
while Wireless eSystems scrolls across the base’s
screen.
3. When Device Address appears press ENT
. (This number should not be
altered).
4. Use the up
and down buttons to change the power.
5. Press ENT five more times to save and exit configuration mode.
6. The base will automatically shut off.