User Manual

Wireless Dynamics Inc. SDiD 1010 User Instructions
LED Specification
The SDiD 1010 has an integrated LED that is used to indicate the card status. The
following table shows the different LED states and the corresponding card status:
LED Status Indicator
Card Status LED State
Standby Mode OFF
Reader/Writer Mode Two blinks every two seconds
Virtual Mode (Tag Mode) One blink every five seconds
Operating Instructions
1) Insert the SDiD 1010 card into the SD card slot of the host device. The integrated
LED on the SDiD 1010 will initially be ON for two seconds and it will turn OFF
after.
2) Start the application software in the host device.
3) When the card is configured to act as a reader/writer the LED will blink twice
every two seconds. At this point the SDiD 1010 card is ready to read/write
from/to a target.
4) When in virtual mode, the SDiD 1010 will act as a tag and the LED will blink
once every two seconds. In this mode, data can be extracted from the SDiD 1010
card by an external reader.
5) When the SDiD 1010 card is in the Standby Mode, the LED will be OFF and the
SDiD 1010 card will not be able to read/write from/to cards and will not be able
to act as a card until the appropriate mode is selected in the Host Software
Application.
PDF created with pdfFactory trial version www.pdffactory.com