User Manual

Using Multiple RF-250 Wireless Keyboards with a Single Computer
It is possible to use multiple RF-250 Wireless Keyboards with a single RF-000 Wireless Receiver. Do the following:
1. Install batteries in all the keyboards.
2. Using an installed RF-000 Wireless Receiver, press the address button on the bottom of the receiver as you would to set a single
keyboard’s address.
3. Press the ‘Addr’ key on each of the RF-250 Wireless Keyboards. Each time a keyboard gets an address from the receiver, the
receiver will wait an extra 30 seconds for additional keyboards.
Configuring the RF-250 Wireless Keyboard for use with a Macintosh
Configuring the RF-250 Wireless Keyboard for use with a Macintosh computer is a simple process.
1. Disconnect the RF-000 Wireless Receiver from the computer to prevent accidental key presses.
2. Remove the two ‘Win’ and two ‘Alt’ keys from the keyboard by pulling forward on the back of the key until it pops out.
3. Replace these keys with the enclosed two ‘Command’ (clover) and two ‘Option/Alt’ keys. These will snap into place.
4. Reconnect the receiver to the computer.
5. Press both ‘Command’ and both ‘Option/Alt’ keys as the same time. This will swap the key assignments to Macintosh standard.
space
Win Alt
Option
Alt
Command
Windows
Macintosh
Windows
Macintosh
Win
Alt
Option
Alt
Command