User Guide
Table Of Contents
- 1. Introduction
- 2. WCCTV Body Worn Camera
- 3. LED Indicators
- 4. Charging the WCCTV Body Worn Camera
- 5. Mounting the WCCTV Body Worn Camera
- 6. Switching the WCCTV Body Worn Camera on
- 7. PIN Screen
- 8. Home Screen
- 9. Recording Video and Audio
- 10. Standby Mode
- 11. Silent Mode
- 12. Switching the illuminating light on
- 13. LTE Status
- 14. Advanced: SD Card Status
- 15. Advanced: GPS Status
- 16. Advanced: Time and Date Status
- 17. Advanced: LTE Status
- 18. Advanced: Battery Status
- 19. FCC Radiation Exposure Statement
- 20. Interference Statement
Support Guide: WCCTV Body Worn (Connect)
15
16. Advanced: Time and Date Status
Pressing the Time and Date on the main screen of the WCCTV Body Worn Camera will
bring up for the following information:
current firmware on the unit, build time and date, uC version, uCBL version and FPGA
version.
You also have the option to manually check for an update.
If the time and date of the unit is incorrect, simply get a GPS signal and this will update
automatically or place on the WCCTV Smart Hub and allow the unit to pull the correct
time via NTP.
Please note: The WCCTV Smart Hub must be connected to the internet for video
upload to the cloud and NTP time checking