User Guide

Support Guide: WCCTV Body Worn (Connect)
10
9. Recording Video and Audio
To begin recording on the WCCTV Body Worn Camera press and hold the top red button
for two seconds on the side of the unit.
The LED indicator at the top of the unit will turn red and the unit will make an audio
notification - beep once to signal recording is activated.
Please note: if silent mode is activated the sounds and LED indicators will be
switched off.
Whilst the WCCTV Body Worn Camera is recording, you can take a still image by
tapping the screen, the unit will make a higher pitched beep to indicate the image has
been taken.
To stop recoding, press the lower grey button on the side of the unit.
The LED indicator at the top of the unit will revert to flashing yellow and the unit will beep
to confirm the WCCTV Body Worn Camera has stopped recording.
10. Standby Mode
After two minutes of inactivity, the WCCTV Body Worn Camera will automatically go into
standby mode to preserve battery.
When standby mode is activated the screen will go black and the LED indicator at the top
of the unit will intermittently flash .
To get the unit out of standby mode, simply touch the screen of press the red button on
the side of the unit once.
Recording can still be activated straight from standby mode.