Installation Guide

Wireless Cables Inc.
2880 Zanker Rd, Suite 203
San Jose, CA 95134
Phone: [phone]
Fax: [phone]
Email: [e-mail]
This mobile device is intended for general use.
THE TRANSMITTING ANTENNA MUST BE LOCATED MORE THAN 20cm AWAY FROM
THE BODY OF USER AND NEAR BY PERSON.
1) The transmitter module may not be co-located with any other transmitter or antenna.
As long as condition above are met, further transmitter test will not be required. However,
the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not be used on the final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following:
“Contains FCC ID: SQCAB5C1”.
Manual Information That Must be Included
The users manual must include the following information in a prominent location:
Example Sticker:
This Transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter. This equipment complies with FCC RF radiation exposure limits set forth for
an uncontrolled nvironment. This equipment should be installed and operated with a minimum
distance of 20 centimeters between the radiator and your body. Any changes or modifications
(including the antennas) made to this device that are not expressly approved by the manufacturer
may void the user’s authority to operate the equipment.
IMPORTANT NOTE: