Product Manual
Stinger User Manual Page 7 of
33
the plastic housing of the subscriber module. The module is now properly aligned within the
reflector.
INSTALLATION OF THE SUBSCRIBER MODULE
When power is applied to a Stinger module or the unit reset via the web-based interface,
the
module will take approximately 25 seconds to boot up. During this boot up time, power on
self-
tests and other diagnostics are being
performed.
The following steps must be performed for successful
installation:
•
Select a mounting location that is free from objects, such as buildings, large trees, etc.,
that
will interfere with the line of sight to the Access Point cluster location. Be mindful of
the
Fresnel
Zone.
•
The Stinger module should be mounted vertically as shown in FIGURE 3. All
Stinger
modules’ antennas are vertically polarized in this
direction.
•
Mount the Stinger subscriber module to a secured location on the side/roof of the
building.
The mount must be rigid and the subscriber module must not sway from outside
forces.
•
Illustrated in FIGURE 3 is an example of mounting the unit to an antenna mast.
BareStinger
(BareSM)