Product Manual

Stinger User Manual Page 2 of 33

NOTICES

U.S. Federal Communication Commision (FCC)
This device complies with part 15 of the U. S. FCC Rules and Regulations Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the U.S.
FCC Rules These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses, and can radiate
radio-frequency energy and, if not installed and used in accordance with these
instructions, may cause harmful interference to radio communications. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to correct
the interference by one or more of the following measures:
• Increase the separation between the affected equipment and the unit;
• Connect the affected equipment to a power outlet on a different circuit from that which the receiver is connected to;
• Consult the dealer and/or experienced radio/TV technician for help.
• Reorient or relocate the receiving antenna.
Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate the
equipment.

FCC IDs and Industry Canada Certification Numbers are listed in the following table:
Module
Types
Operating Frequency
Range
Maximum
Transmitter
Power
Reflector, Stinger,
Superstinger
FCC
ID
SM AP BH ISM 2403-2483 MHz 500mW Allowed on SM and BH S4D STINGER-01



FCCRFExposureStatement

ThisequipmentcomplieswithFCCradiationexposurelimitssetforanuncontrolledenvironment.
Thisequipmentshouldbeinstalledandoperatedwithminimumdistance20cmbetweenthe
radiatorandyourbody.WhenusingtheClassicStingersliponreflectorthesystemmustbe
installedtoprovide
aseparationdistanceofatleast40cmbetweentheradiatorandyourbody.
WhenusingtheSuperStingersliponparasiticantennathesystem mustbeinstalledtoprovidea
separationdistanceofatleast64cmbetweentheradiatorandyourbody.Whenaddingthe
Stingerreflectordishthe
reflectordishmustbeinstalledtoprovideaseparationdistanceofaleast
1mbetweentheradiatorandyourbody.

Thisequipmentisinstalledbyprofessionalinstallerswhichareinstructedandtrainedtolimitthe
RFexposureduringinstallation.

Thistransmittermustnotbeco‐locatedoroperationin
conjunctionwithanyotherantennaor
transmitters.
GETTING ST ARTED

WELCOME
Congratulations on the purchase of the Stinger subscriber module from WB Manufacturing! The
Stinger subscriber module is the latest innovation in high-speed wireless networking that lets
you
easily network at high speeds.
FEA TURES
The following is a subset of features included with your Stinger subscriber module: