Product Manual
be in the following format,
0a-
00-3e-xx-xx-xx.
Software Version:
displays the version of the software that is currently loaded into the
module.
Please make note of this information when obtaining technical
support.
FPGA
Version:
displays the version of the FPGA (field programmable gate array) that is
currently
loaded into the module. Please make note of this information when obtaining technical
support.
Uptime:
displays the length of time the module has been operating since a rest of the
module
occurred.
System Time: displays the current time, which is inherited from the Stinger System via
the
registration to an access point module. When the module is registered to a Stinger System
where
a Cluster Management Module (CMM) is being utilized the time is displayed in Greenwich
Mean
Time
(GMT).
Ethernet Interface:
displays the configuration of the Ethernet interface on the
module.
Session Status:
displays the current session state the module is in. There are five (5)
options
that will display in this field,
scanning, syncing, registering
,
registered, and alignment
•
Scanning – module is cycling through the RF frequencies that it is configured to scan and looking
for
an access point
module.
•
Syncing – module is attempting to synchronize timing to a single access point
module
•
Registering
– module sent a request for registration and is awaiting a
response
•
Registered – module is locked on to a specific access point module and ready to transmit
and
receive data
packets
•
Alignment
– module is in alignment
mode
RSSI: displays the current value for the Radio Signal Strength Indicator. This parameter will
only
display information when the module is registered to an access point module and the value is
only
updated by either refreshing the web browser screen or configuring the Stinger module to
auto-
refresh (see
Configuration
web page.)
An acceptable RSSI value for a registered link is
greater
than 700
; however it is important to view this value in conjunction with the
Jitter
value.
Jitter:
displays the current value for the quality of the received signal. This parameter will
only