Operation Manual

2 / 3
2, If the transmitter WTX works with Lite Headphones
2.1 HEADPHONE ADJUSTMENT
Before wearing the lite headphone for the first time you should adjust it properly to achieve
the best sound and ambient noise attenuation.
Unfold the headphone pad as the figure 1. and 2. Select the appropriate lock-in position on
both sides of the headband as figure 3. The pads will adjust the angle automatically according
to your head size.
2.2 POWER ON TRANSMITTER
Make sure the transmitter is fully charged and press the power button for 1 second. The LED
indicator will start to flash. The battery condition LED will indicate the battery life for 3 seconds.
2.3 POWER ON HEADPHONE
Make sure the headphones are fully charged and press the power button (between two
volume buttons) for 1 second. The LED indicator will start to flash.
2.4 PARING (when necessary)
If you need to pair them again, please place the Lite Headphones to within 10cm of the
transmitter, press and release the power button of the headphone quickly. The LED indicator
of the transmitter will change to steady condition.
3, If the transmitter works with Pro Headphones
3.1 POWER ON THE TRANSMITTER
Make sure the transmitter is fully charged and press the power button for 1 second. The LED
indicator will start to flash RED light. The LED indicator will turn to still when connected with
the Pro headphones.
3.2 POWER ON THE PRO HEADPHONES
Keep press the power button for 2 seconds to power on. The status LED will start blinking
when powered on. The headphones will connect with the last paired transmitter (powered on
condition) automatically.
3.3 PARING (when necessary)
When the Pro headphones is not connected with the last transmitter it will blink at a fast
frequency. You just need to press the headphones power button once quickly near the new
transmitter (powered on condition). The headphones LED will blinks at a slow frequency when
pairing successfully.