Specifications

© Wired Rite Systems, Inc. 800-538-7483 www.wiredrite.com Docsst-4-01.8 Rev 0 Page 11
TEST MODE OPERATION:
Test Mode is used to verify the wiring and operation of the system.
CAUTION: when in Test Mode, the vehicle or Emergency Pump may start unexpectedly.
Whenever possible, Test Mode should be used for bench testing. If used when installed, two
mechanics should be present, and extra care is strongly advised.
To enter Test Mode, press and hold all three buttons: “MENU”, “UP”, and “DOWN” for ve seconds
until all of the segments ash in the middle two 7-segment displays.
To verify each of the items shown in the table below, perform the user action, and verify the resulting
display.
Verification Of Relay
Functions
User Action Resulting Display
Ignition relay & T1
Throttle relay
With ignition ON press MENU button on SST-4 board
(WARNING: Vehicle may start)
Starter relay & T2 Throttle
relay
With ignition ON press Up button on SST-4 board
(WARNING: Vehicle may start)
Emergency Pump relay
With ignition ON press Down button on SST-4 board
(WARNING: E-Pump may start)
Verification Of Installation Wiring User Action Resulting Display
Board Power (TB1, Position 3) Apply power to board
Ignition Power (TB1, Position 6) Turn ignition key ON
Power from Master switch (J1, Pin 3) Turn ON Master switch
Remote E-Power input (J1, Pin 2) Activate remote E-power switch
Remote Start/Stop input (J1, Pin 5) Activate remote Start/Stop switch
Remote Throttle input (J1, Pin 4) Activate remote Throttle switch