Operator`s manual

12213 1200.01
13
Once you are certain that your tow vehicle
is equipped with a properly sized, rated,
and positioned ball, raise the trailer on the
tongue jack so that the ball of the tow
vehicle can be maneuvered directly
beneath the ball socket of the actuator.
Remove any safety lock pins from the
actuator lever and move the lever to the
forward position. Crank the handle of the
tongue jack and lower the actuator socket
over the tow vehicle ball. Once you are
certain the actuator is fully seated on the
ball, move the latch to the engaged
position and insert the safety pin through
the actuator slider in the hole located
directly behind the ball socket. Continue to
lower the tongue jack to its fully retracted
position. Rotate the jack to its horizontal
position for travel.
Attach the safety cables from the trailer
to their proper and respective
attachment points on the tow vehicle.
Make certain the quick-link fasteners
are properly positioned and completely
tightened. Attach the safety brake
activation cable from the actuator to
the tow vehicle adjacent to one of the
quick links.
Your trailer should now be properly and
safely mechanically attached to your
tow vehicle. Proceed to electrical
system attachment.
Actuator - Latch Open
Safety
Pin
Latch
Lever
Forward
Actuator - Latch Engaged
Insert Safety
Pin Here
Latch
Lever
Engaged
Quick Link
Attached
Emergency
Breakaway
Cable
Attached
Properly Attached Trailer
Safety Pin
Inserted
Latch
Lever
Engaged
Quick Link
Attached