User guide

THE WEB CONFIGURATION SYSTEM
With the exception of initially setting the IP address, all of Masonʼs settings are
made using its web-based configuration pages. To access the configuration
pages, you simply enter the IP address of your Mason into the address field of
your favorite web browser on your computer.
You can always find the current address of your Mason by pressing the ʻsetupʼ
button on the remote control.
Current address
of the Mason
If you were unable to set the IP address in the earlier steps because
your monitor could not display the default resolution, you will need to
connect to the configuration page using the default address of
192.168.1.10. If the rest of your network is not using 192... addresses,
you will need to temporarily connect your computerʼs Ethernet directly
to the Masonʼs Ethernet port, using a standard Ethernet cable. This
should allow it to communicate with the Configuration page so you can
set the resolution.
1. On your computer, enter the Masonʼs IP address in your browser and
press ʻenterʼ.
2. A browser authentication window will appear. Enter the user name and
password and press ʻreturnʼ or click the OK button in your browser.
We ship the Mason with the user name set to ʻadminʼ, and the pass-
word ʻadminʼ. If you have reset the Mason to the factory defaults, then
there there will be no user name or password set.
Mason User Guide! Jan 2008! 11 of 27