PDVR Manual MODEL: V700GC, V700GM This picture may be changed without any notice. -0- http://winycam.
Before Using – Please read this user manual carefully before using. ● SD card that support over 512MB / under 16GB is recommended to use. ● Use only specified AC/DC and voltage. (Input: DC5V, Output: 12V 150mA) ● Connect adapter correctly, otherwise it causes damage. ● Turn off PDVR when you plug in and off an external camera, it cause damage. ● Do not use the location where it rains and is humid, this product is not waterproof.
Contents 1. Packaged Items 2p 2. Feature 3p 3. Part name and Functions 3p 4. Before Setup 4p 5．Setting Menu 6p 5 – 1. Time Setup 6p 5 – 2. Record Setup 6p 5 – 3. System Setup 8p 5 – 4. SD Card Info 11p 5 – 5. Version Info 11p 6. How to use 12p 6 – 1. Video Recording 12p 6 – 2. Snap Shot 14p 6 – 3. MP3 Player 15p 7. Other Accessories 15p 8. Recoding Time List 17p 9. After Sales Service 17p 10.
2．Feature ● Palm size SD recorder. ● Can check recorded video image directly by PDVR body with built-in color CMOS camera. ● Have 1.8 inch display. Can check recorded video by body. ● 1.8 inch LCD display on body. ● Record the moment of accident by built-in G-sensor (Car Mode only) ● Play audio file (MP3) by MP3 player.
1.Built-in camera Record image by built-in camera / Connecting with wide-angle lens 2.SD CARD slot Insert SD CARD 3.Microphone Audio recording 4. 1.8” LCD monitor Confirm recorded image on LCD monitor 5.REC Key To start recording / take snapshot 6. Rec LED light Recording: LED lamp flash green Screen save mode: LED lamp flash red Right: Go to replay screen / delete file / rewind Left: fast-forward / protect file Press 2 sec: Invert right and left at stand-by mode 7.
② Insert SD Card when power is off. ※ Check insertion direction ③ Charging Connect AC adapter jack. As soon as AC adapter connected, it started to charge and light is on.(Charging: Red / Completed charging: Green) It run 3~4 hours on 1 hour charge. ※ With using external camera (without external charging), the recording time will be around 1hour to 1hour and half. ④ Power Press 2sec (CLR ) to power on and check monitor display.
⑨ External Camera As following left picture, connect enclosed Video cable to PDVR and external camera ※Video cable: Black-external camera 12V 150mA Yellow-video input, Blue-video output ※To use external camera, set up <>. ※Depend on external camera, BNC jack or RCA jack would be required ※Turn off power when plug / plug-off a video cable. 5． Set-up After power is ON, press Ｍ, setup menu and 5 items are displayed.
[5-2-2. Mpeg Codec] Set up what Mpeg Codec the image is compressed. [5-2-3. Quality] Set up the image quality. Select NORM (normal quality) / HIGH (high quality) / LOW (low quality)and press Ｍ to save. [5-2-4. Resolution] Set up the image resolution. Select <<320*240>> /<<640*240>> / <<640*480>> and press Ｍ to save. The resolution is different when external camera is used.
[5-2-9. Audio Quality] Set up audio quality. [5-2-10. Motion Rec] Recording will be started only when some motion. Setup motion REC Create file LED status at motion REC After setup, press REC, green check will be shown if motion sensed and start recording. File will be created as setup file size. Minimum every 1min file is created. Flash light green: Recording / Light Green: Stand-by [5-2-11. Motion Sense] Set up motion sensitivity on motion detection function.
[5-3-2. Camera Mode] Set up built-in camera or external camera to use. Select <> (built-in camera) or <> (with external camera), When <> is set up, packaged AV cable should be used. ※Turn off power when plug or plug-off an external camera. It causes damage. [5-3-3. Adjustment] Select BRIGHT / CONTRAST / Color/ Exposure. Scroll or to set preferred Brightness. Press Ｍ to save. Brightness level is 0~100, when PDVR is format, the value will return to initial setup value.
[5-3-7. Orientation] Depend on when it is installed, can set up inversion image each built-in and external camera. Select <> (LCD is an upward direction) or <> (LCD is turned over.) [5-3-8. Screen Save] Set up screen save function to save a battery <> The display turns off automatically after 20seconds last key is pressed. Recording or power off can be confirmed LED light.
[5-3-13. F/W Upgrade] Upgrade the firmware. a. Get the latest S/W from our distributors contact and down load to your PC b. Copy down loaded S/W to your SD card PC c. Insert SD card to CARD slot of PDVR. Power on and press CLR d. Select【13. F/W Upgrade】in【3. System Setup】and pressＭ e. Select <> (upgrade) with or and pressＭ Upgrade will be completed in 10 second as shown left picture. * Note: Power should be kept ON. f.
6． How to use 6 - 1．Video Image SETUP: Menu Ｍ bottom-> 3. System Setup -> 1. Mode Select -> <> Record starts after pressed 'REC'. Press CLR to stop recording LED light is blinking green during recording. [6-1-1. CAR MODE / NORMAL MODE switch] The mode switch can be seen when battery removed as left picture. Power CAR Record MODE Parking monitoring (Motion REC) Recording starts automatically when car engine started and stop recording when stop engine. Always-record.
[6-1-2. Play Video] a. Play on the PDVR Press on stand by mode, recoded file lists is shown. ◎ Key operation ◎ / Volume control/ audio output / Fast Forward/Rewind playing if press longer. Press once, move frame each 5sec Ｍ Play / Pause CLR Stop b. Play video image on the PC Recorded image on SD card can be shown on PC with connecting SD card connect to PC. ※Note: Normal multimedia software should be downloaded to your PC to play recorded image before using.
e. File Protection Recorded video by G-sensor or user setup to protect some files can not be deleted. Select file and press in file list. Select <>. Protecting file will be marked red letter. Mac 70 files can be protected. But if you format or delete file with your intention, file can not be protected. If file will be over 70files, oldest file will be over written. f. Delete File Press after selected file and select <>, then pressＭ to save. To cancel deleting file, select <> or CLR .
6 - 3. MP3 player Can play MP3 music file by PDVR. Menu Ｍ button-> 3. System Setup -> 1. Mode Select -> <> Insert SD card to PDVR, the file of “MUSIC” will be shown on display. Input music file to this folder and play.
■ External Camera (option) No need additional external power if external camera is 12V, but external camera dose not 12V, the adapter for external camera should be used. ※ Refer 4. Before Setup -> External Camera ※ Refer５－３．System Setup -> [2. Camera Mode] ※ External camera is not included in package. Please prepare customer side. ※ We are not responsible for external camera. ※ Please use specified voltage for adapter and external camera. Otherwise it might cause product damage.
8． Recording Time List ※ Please refer above list as standard. The result is came from best condition of PDVR, there might have some differences. ※ Depend on moving location, brightness on the place, the result might be changed. ※ Rec Time is longer with Low quality as well as Low Frame Range.
10．Specification Model Lens Angle Lux Image Sensor V700GC 3.02mm(F2.5) 120˚ 1Lux 1/4” CMOS, 300,000Pixel V700GM 1.79mm(F2.0) 62.8˚/150˚ 1Lux 1/4” CMOS, 300,000Pixel LCD External Camera Image Sensor 1.8Inch TFT Unser 12V 150mA 1/6inch CMOS CAMERA. 300,000 pixel G-Sensor Built-in G-sensor (CAR MODE ONLY) Recording MPEG4, H.264 Video In/Out jack NTSC/PAL COMPOSITE (1.
