User Guide

NTRecover
Winternals Software LP Page 13
7.2.2 Baud Rate
Specify the communications rate that is to be used between the host and the
client. Most computers can support the maximum serial rate of 115200 baud,
but this is dependent on variables such as the quality of the serial cable, the
speed of the host computer, and the type of serial controllers present on the
two computers.
If the client software displays a high number of retry operations (several
dozen over a few seconds), or if no communications is established when a
connection is attempted, you will need to lower the baud rate the next time
you run NTRecover. In the current version of NTRecover, you must reboot
the host to try another rate if a connection has already been made.
7.2.3 Disk
Choose the physical hard drive that you want to access from the host. Only
one disk, which can contain multiple logical drives, can be accessed at one
time.
Once you have entered your selections for the above settings, press enter to
have the client wait for a connection attempt from the host.