User's Manual

5
5
10ms
15ms
20ms
7 times
On/off setting of ignition # 2 output while cranking
ON
OFF
OFF
OFF
31 Features Programming Table ( 2 )
Follow the steps as below.
(1) Turn the ignition ‘Off”
(2) 【Total 3 times press of override switch for valet mode】
【Total 4 times press of override for programmed daily start time】
【 Total 5 times press on override for temp-controlled auto start.】
Same number of presses on override switch is followed by same numbers of siren chirps.
(3) Turn the ignition “ON” to decide in each features mode.
(4) Press again override switch once /twice to decide each feature “ON” or “OFF”
※ The shaded indication like OFF is the factory default modes.
Features Program Table ( 2 )
Once
Twice
3 times, valet
ON
OFF
4 times, programmed daily start time on/off
ON{ Refer below note}
OFF
5 times, time-controlled auto start on/off
ON
OFF
Siren and L E D indicator
1
2
Note: NOTE: Having set the programmed daily start time mode “ON” , when the ignition is turned “OFF”, the engine will
immediately be running to indicate this feature in at standby mode .( Use remote control to engine stop engine running in this
case.)
32. How to restore setting to factory default.
Follow the steps as below.
(5) Turn the ignition “ON” ( Engine must not be running)
(6) Press and release the override switch 10 times.
(7) Turn the ignition “ OFF” ( Siren chirps 10 sounds. This confirms system has entered features programming
mode.)
(8) Press over-ride switch.1 more time. Siren chirps 1 time to confirm the # 30, #31 are ready for change of
default
(9) Press remote’s button Ⅰ 【 】Its buzzer makes 1 sound to confirm # 30, # 31 are restored to factory
default.
Over ride switch
Features programming