User's Manual

23. Valet mode by override switch [ Refer to Features Program Table ,at # 32 ]

While valet mode”ON”, all other functions are still operative except for the engine-start which will not be

operable unless valet mode is switched “OFF”.

24. Auto relock

After car door is unlocked , it will automatically relock itself if nobody opens the door within 15 sec.

25. Safety door lock/unlock upon ignition on/off [ refer to Features Program Table, at # 33 ]

The central door locking system will be activated and all doors are automatically locked if the ignition is turned

on. All doors will be unlocked immediately the ignition is turned off.

26. Immobilizer by-pass features [ Refer to Installation diagram note ( 5).]

In case of inability to remote start your car with original immobilizer, this system feature can overcome this

problem by means of by-passing the immobilizer feature.。

27. Remote start with automatic and manual gear [ Refer to Installation diagram note (10) ]

Auto transmission gear : The remote transmitter is compatible with this type. The automobile must be in free

gear mode otherwise the auto remote start is not operative.

Manual gear car : To enable remote engine start for this type, following steps must be done.

(a) Engage the hand brake while the engine is running

(b) Press the remote engine start button of the remote transmitter and try to complete steps (c) and ( d )

within 30 secs.

(d) Open the car door and re-close it .Power door lock is activated.( The engine will automatically

stop running at the same time). All the features become operative now.

※

If there is any mistake in any of the above steps, the system can fail its remote engine start.

28. LED Status indicator

Mount the LED status indicator in the interior of the car at an visible place. Car owner can learn the current

setting status of main unit. Refer to the table below.

Normal mode

* * * * * * * * * *

Programmed daily start-time in standby mode

** ** ** ** ** ** ** **

Temperature-controlled start in standby mode

*** *** *** *** *** ***

Temperature-controlled & daily start-time in standby mode

**** **** **** **** ****

Valet mode on

***** ***** ***** ***** ***** *****

29. Code learning of remote transmitters

Follow the steps as below.

(1) Turn the ignition “ON” ( Engine must not be running)

Press and hold override switch for about 6 sec and release after the siren chirps 4 times when the main

system has entered learning mode.

(2) Press and hold remote transmitter’s button , and simultaneously till the siren chirps 1 time. Do

the same step (2) with other remote transmitters one after another , to let the main system learn codes of

each transmitter. (maximum 4 remotes can be learned )

※

Note: The previously-memorized coding will be erased each time learning mode is activated.